Packaging Air Leak Tester
Packaging Air Leak Tester Packaging Flim & Paper Board Testing  Melaka, Malaysia, Ayer Keroh Supplier, Suppliers, Supply, Supplies | Carlssoon Technologies (Malaysia) Sdn Bhd

Introduction:

R.ALT.S-A.010 Leak tester is a kind of tester that use compression air to produce negative pressure by vacuum device to test the seal capability and processing technique of soft plastic packaging material. It has advantages of easy operation, novel design, convenient to observe test result, especially to detect some tiny pole leak.

Application:

It is applicable in testing the seal of soft packaging in food and pharmaceutical industry, etc. It can test the seal capability of soft packaging accurately, which provides scientific date for relative technical requirement. It also can test the specimen which has done drop and compression test.

Work principle: 

Through vacuumizing the vacuum chamber to let the sample dipped in the water and it will cause an inside and outside pressure difference. By observe the air leak or water permeate case to judge the seal capability of the sample.

Air pressure difference between the inside and outside of the sample —- air expand — air leak— air new balance— air rate rise in the inside of the sample— air expand rate rise— sample receives bigger pressure— air leak stronger.

Remark: the parameter’s set is according to the products’ inside air rate, for example, the high air rate of the sample, the high inside air expand rate, so the vacuum pressure should be set lower.

Standard

GB/T 15171ˇ˘ASTM D3078 -1994, GB/T27728

Specification:

Vacuum degree : 0ˇ«-90 kPa
Accuracy : +/- 1%
Internal chamber size : §¶270mm×210mm(H) (Standard)
: §¶360mm×585mm(H) (Optional)
: §¶460mm×330mm(H) (Optional)
Compression air pressure range require : 0.5 ~ 0.7 mPa
Power : AC220V 50Hz

Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version